HAND HYDRAULIC TABLE TRUCK TF30A TF50A
|Load Capacity||300kg 660lb||500Kg 1100lb|
|Length of Handle||970||970|
1. Upper platform lifted with aluminum safety bar preventing
descent on contact with obstructions.
2. Internal power pack equipped with relief valve against
overloading and compensated flow valve for controlled lowering
3. Heavy duty cylinders with drainage system and check valve to
stop the lift table lowering in case of hose burst.
4. Safety clearance between scissors to prevent trapping during
As above all have the common function and features:
1.Use the products of our company can greatly improve the
efficiency of production and work .
2.Save the lifting and handing ,stacking the cost of the equipment
3.Can solve warehouse ,workshop,storehouse ,wharf and other kinds
of places of material ,handing ,stacking,picking,ext
4.These model have characteristics :for example :more safe,reliable
and flexible convenient and so on
5.Hand hydraulic products also can be applied to have strictclean
environment protection,fire protection ,place of riot requirements
6.fixed electric hydraulic life platform products,not only have all
freight elevator function ,but also has hoisting height,mesa
specification size,according to the different need of each customer
Should lifting warning devices be part of a'Thorough Examination'?
Yes. Devices fitted to machines, such as cranes, which cut-out
hoisting, derricking or trolleying motions, eg when the SWL is
exceeded, should be regarded as part of the lifting equipment and
be included in the thorough examination. This applies also to any
radius/load indicator fitted to lifting equipment.
•Are pallets,skips,ladles or similar considered to be lifting
•Usually no. Where this equipment is used for carrying material
loads and are not permanently attached to the lifting machinery it
would normally be considered to be part of the load and a 'Thorough
Examination' is not required. The equipment should be maintained
and inspected to make sure it can be used safely including when it
is being lifted.
1. Use & applicable range
It is a convertible vehicle using for lifting and transporting in
workshop, workshop, warehouse and wharf, etc.
2. Basic Data:
Model: TF 30
Load Capacity: 300kgs
Lift Height: 900mm
Lowest Height 280/380mm
Table Dimensions: 825×500×50mm
Packing Dimensions: 900×520×300/400mm
Net Weight: 76kg
I. Insert the handle (#18) on the frame seat (#45) and fix them by
II. Put the foot pedal rod (#44) on level position and insert shaft
(#42) in this hole , and fix them by lock pin (#41).
III. Put foot pedal board on level position, and fix them by
special screws .
I. Test the cart before using it. Firstly step the foot pedal rod
to lift the table to the max height , and then release the limit
oil valve to check whether the cart is ok .
II. Please fix the cart and to break the wheel before loading.
III. Adjust the table’s height by step the foot pedal lift up and
down to load or unloading in its rated loading.
IV. When lower the table, open the check valve.
① Read and understand the instruction manual before assembly and
② Do not load the goods over the rate capacity .
③ Do not allow people to sit or ride on the cart .
④ Keep feet and hand away from under the lowering table . Suggest
to wear safety shoes during operation.
⑤ Do not put your foot on the pedal of the wheel when table
lowering down .
⑥ Put the goods on the some place of the table occupy more than 80%
area of the table .
⑦ Do not use the cart on the slope for safety .
⑧ Do not move the cart when table with goods on the high site .
⑨ Failure to operate the cart will cause the damage to the person
health or property loss.